What are the different ways you can you tell if this part is steel or aluminium.
Design Coordinator Interview Questions
6,139 design coordinator interview questions shared by candidates
If you have a cantilevered beam with a load at the unsupported end, what can you change about the beam to mitigate the effect of the load.
What would you like to design / your future?
need to join tomorrow are you ready?
Explain the design patent process. This isn't that difficult without proper research here and on their website.
How is processor performance affected when the instruction cache hit latency increases? How do you overcome that?
Questions that popped out as I can remember. 1) A cube (1-1-1m) of ice in a room (50C) sitting on a wooden table. the ice is 1m away from the walls around it's 4 sides, except for 1 side is 30cm away. You're given 2 insulating blankets (1m by 1m) that can be used to cover the ice block. The goal is to keep the ice in solid form as long as possible. Where would you put the blankets? 2) 2 rectangular beams, one is Aluminum a by 2b cross-section one is Steel a by b cross-section. If you were to climb a mountain and find these two sticking out on a spot where you need to rest, which one would you latch on to? 3) Interviewee shows a plastic part and asks: How do you think I built this part? What other ways can you think of this part could have been done?
Most of the technical questions focused on power supply design. For this position this is a one of the more difficult tasks so they want to know how switching regulators work and different trade offs involved.
Questions on C and details of the previous projects carried out
Design a divide by 3 counter. Bonus for 50% duty cycle
Viewing 1 - 10 interview questions